BSP Killer Notes for the Linksys WRT54GS2V1


------  VxWorksKiller-GS2V1.bin  ---------


1. Reset the router to defaults on the Linksys Admin page, and let it reboot
or manually reboot it after its finished.

2. Set your computer to a static IP address of 192.168.1.10 and 255.255.255.0 for a mask 
and plug ethernet cable into LAN port of the GS2v1 unit.

3. Log in admin page (username is blank, password = admin) and navigate to firmware 
upgrade page. Browse to the VxWorksKiller-GS2V1.bin file, press Upgrade and wait 60 
seconds for it to reboot on its own, if it does not, then powercycle the router manually.
Wait another 60 seconds and reboot it again. Router should now be listening for tftp 
transfer of dd-wrt firmware.

4. Tftp the DD-WRT firmware to the router, use latest "dd-wrt.v24_micro_generic.bin" 
from the folder where you got these instructions;  after sucessful tftp, wait 3 min for 
the router to finish writing new nvram deafults, etc... It should reboot on its own at 
least two times, so give it 3 min and then go to http://192.168.1.1 (If it not reboot 
on its own, wait another 1 min, and then power cycle it)

5. When if finishes booting up...do a hard reset on the unit...let it boot again, 
and configure.

6. Don't forget to set your computer back to automatically obtaining DHCP and DNS.